Now, using your pencil, mark where the second hole should be on your door. If not, hold the pull up against the template and line it up with the two holes that you’ll use to mark your cabinet. I know it’s hard to see but the lines on the templates all have measurements written on them. If it does, great! Find that measurement on the template and line one of the holes up with your existing hole. Look at one of your new pulls and see if it says the distance needed between the two holes (mine said it right on the packaging). If you’re going from knobs to handles, you’ll need to drill a second hole in your cabinet door. Ok, now that you have all your supplies, let’s get started on how to replace your kitchen cabinet hardware! Step 1: Drill New Holes (If Needed) The hole was big enough to use a pencil to make a mark, and then I could use my drill to make the hole. They were the absolute best! They let me use the existing hole from the old knob and measure to exactly where the second hole needed to be for the pull. My dad gave me these to help me make the new holes I needed, since I was changing from knobs to pulls (knobs require 1 hole and most pulls require 2). A power drill and impact driver (I love my Ryobi Power Drill/Driver Set).A screwdriver (check out my favorite one–the Buck Brother 6-in-1 screwdriver at your local Home Depot if you don’t have one you love).New Hardware–I love our Liberty Mandara knobs and pulls in Cocoa Bronze from the Home Depot!. ![]() Here’s everything you need for how to replace your kitchen cabinet hardware: To buy all the pulls and knobs we needed, it cost us about $50–not bad for how great the finished product looks! Supplies Needed ![]() ![]() We went with 4 inches for most of the cabinet doors, 3 inches for the smaller ones above the refrigerator and microwave, and a 5 inch one for the big pantry door. The Bronze color is almost black, which we loved!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |